Below is a guide to solving common issues in DroneDeploy. If this is your first flight, please see our initial setup guide.
Top two issues:
If the checklist passes, but the drone won't take off, make sure you're on the latest version of firmware and have Multiple Flight Mode enabled in DJI GO.
If the camera check fails, format your SD card in DJI GO.
The DJI GO app
The GO app is great for debugging issues. If the drone won't takeoff in our app, give the GO app a try to see if there are any strange warnings or calibrations required. However, make sure the DJI GO app is closed while running DroneDeploy. Only one app can have access to the drone at a time- having both apps open will mean neither app works. Please make sure to close GO if using DroneDeploy and vice versa.
Most errors are caused by incorrect firmware on the aircraft.
You can see what needs updating from the DJI Go app.
Advanced Settings in the GO app:
Enable Multiple Flight Mode should be on
Enable IOC should be off
The correct settings for DroneDeploy compatibility in the DJI GO App.
Try to improve the remote control signal.
If that does not work, open the DJI GO app and:
- Check for warnings.
- Try a test photo.
- Try formatting the SD card.
- Make sure exposure mode is set to Auto (or that Auto settings are disabled in DroneDeploy)
- Try with a different, empty SD card.
In the DJI GO app:
-Check that there are no warnings and that you can take a photo.
-Close the GO app, unplug the USB, reconnect via USB, and choose DroneDeploy from the popup.
Please be sure that you've followed the setup procedure for Desktop Planning and Flying Offline.
Please note that synched plans will not show up unless you are in the area specified for the plan. This means that if you're in your office, and your synched plan is 20 miles away, it will not show up in offline mode until you are closer to the area of interest.
The app is waiting to detect at least 7 satellites. Please restart your remote controller to improve signal, or move to another location with a clear view of the sky if possible.
Check that your drone is in the correct mode, make sure you are on the correct firmware version, and re enter the app.
Check that you have the correct firmware version, and that the USB connection between your device and drone remote controller is secure.
You can manually adjust the camera settings: when connected to the drone,click the bottom left cog and turn on “disable auto camera settings”.
Click on the cog to adjust your flight settings.
Please note: If you choose to do this, you will need to set the camera settings in the DJI Go app before each flight.
You can manually adjust the camera settings in the DJI GO app.